SUP-RD904 Radar Type Level Measurement

Features of Radar Level Meter (Radar Type Level Measurement)

• Small antenna size, easy to install. Non contact radar, no wear, no pollution.
• Almost not affected by corrosion and foam. It is almost unaffected by changes in atmospheric water vapor, temperature and pressure.
• Severe dust environment has little impact on the operation of high-frequency level meter.
• The wavelength is shorter and has better reflection on the inclined solid surface.
• The beam angle is small and the energy is concentrated, which not only enhances the echo ability, but also helps to avoid interference.
• The measurement blind area is smaller, and good results will be achieved for small tank measurement.
• High signal-to-noise ratio, even in the case of fluctuations can also obtain better performance.
• High frequency is the best choice for measuring solid and low dielectric constant medium.

Specification

Product Size

Installation Guide

Be installed in the diameter of the 1/4 or 1/6.    Note: The minimum distance from the tank  wall should be 200mm. Note:  ① datum  ②The container center or axis of symmetry	The top conical tank level, can be installed at  the top of the tank is intermediate, can guarantee  the measurement to the conical bottom	A feed antenna to the vertical alignment surface.    If the surface is rough, stack angle must be used   to adjust the angle of cardan flange of the antenna   to the alignment surface.    (Due to the solid surface tilt will cause the echo attenuation, even Loss of signal.)