Welcome To Meacon Automation Co.,Ltd
Home > > SUP-RD902S Radar Type Level Detector
SUP-RD902S Radar Type Level Detector

SUP-RD902S Radar Type Level Detector

The radar level detector is suitable for non-contact continuous level measurement of liquids, slurries and granular materials, and is suitable for applications with large variations in temperature and pressure; the presence of inert gases and volatiles.


Introduction

The radar type level detector transmits and receives microwave pulses with very low energy through the antenna system. The radar wave runs at the speed of light, and the running time can be converted into a level signal through electronic components. A special time extension method can ensure stable and accurate measurement in a very short time.

SUP-RD902S Non-contact radar with simple commissioning, trouble-free operation saves time and money. PTFE sensor material, for usage in a wide range of applications - be it in simple storage tanks, in corrosive or aggressive media or high accuracy tank gauging applications.

Specification

 Product  Radar Type Level Detector, Radar Level Meter
 Model SUP-RD902S
 Measure range 0-30 meters
 Application High temperature, high pressure and corrosive medium
 Process Connection Thread, Flange
 Medium Temperature -40℃~130℃(Standard type), -40℃~250℃(High temp type)
 Process Pressure    -0.1~4.0MPa
 Accuracy ±3mm 
 Protection Grade IP67
 Frequency Range 26GHz
 Signal Output 4-20mA
RS485/Modbus
 Power supply DC(6~24V)/ Four-wire
DC 24V / Two-wire

Radar Type Level Detector supplier

Radar Type Level Detector factory Radar Type Level Detector manufacturer Radar Type Level Detector wholesale

Be installed in the diameter of the 1/4 or 1/6.   

Note: The minimum distance from the tank 

wall should be 200mm.

Note:  ① datum 

②The container center or axis of symmetry

The top conical tank level, can be installed at 

the top of the tank is intermediate, can guarantee 

the measurement to the conical bottom

 A feed antenna to the vertical alignment surface.  

 If the surface is rough, stack angle must be used 

 to adjust the angle of cardan flange of the antenna 

 to the alignment surface. 

  (Due to the solid surface tilt will cause the echo attenuation, even Loss of signal.)